Figure 12: An example of network connections for one shared network
71 Management port eth0a on controller AHost/server
2 8Network Interface Cards (NICs) Management port eth0a on controller B
93 Data port eth2b on controller BEthernet switch 1
4 10Ethernet switch 2 Host network connection
115 Management interface pairArray
6 12Data port eth2b on controller A Data interface pair
Two Dedicated Networks
In this configuration:
• Management and data paths are on different subnets or networks
• Port eth0a and eth0b handle management traffic
• Ports in slot 1 (eth1 ports) through slot 3 (eth3 ports) handle data traffic
In the following example, the eth0a port on each controller provides the management path (red cables). The eth2b port on
each controller provides the data path (blue cables). The management and data ports connect to different network switches.
The host also connects to both switches. The separated management and data paths on this network provide higher performance
and high availability.
Note that only one management connection and one data connection are shown. You can add more connections and use
different ports as needed.
Install the HPE Storage Array 27
Documentation Feedback: doc-feedback-hpe-storage@hpe.com