2. Open the browser and select the array from the HPE Storage Setup Manager for Windows list.
If the array is not visible in setup manager, verify that the array is on the same subnet at the Windows host.
3. In the Information dialog, click OK.
Results
The HPE Cloud Connectivity Wizard opens to guide you through the process of connecting the storage array to HPE GreenLake.
Connect the Array to HPE GreenLake
The HPE Cloud Connectivity Wizard guides your through the process of connecting the storage array to HPE GreenLake.
Before you begin
Procedure
1. Click Get Started.
2. Read and accept the end user license agree, then click Continue.
3. Specify the following network settings, then click Continue.
• IP address
• Netmask
• Gateway
• Domain Name
• DNS Server IP
4. If using a proxy server to connect to the internet, select Use proxy and specify the following, then click Continue:
• HTTP Proxy Server
• HTTP Proxy Server Port
• Proxy Server Username
• Proxy Server Password
5. Specify the following time information, then click Continue.
• Time (NTP) Server
• Region
• Country/State/City
Important:
Maintaining the system time within 2 minutes of the correct time is required to initialize and manage an HPE
Alletra storage array with Data Services Cloud Console. To maintain the array time within the tolerance, synchronize
the array time with an accurate, highly available NTP service that is synchronized with global time services.
If the array time on an uninitialized array is not within the tolerance, the lack of a connection to Data Services
Cloud Console will prevent the array from being initialized. Setting the array time within the tolerance will enable
the connection to be established and allow you to begin the initialization.
If the array time on an initialized array is not within the tolerance, the array will not connect to Data Services Cloud
Console. Or, if the array is already connected, the connection will be lost. A lost connection can happen if the array
time is set incorrectly, or if the array time drifts beyond the tolerance. Resetting the array time within the tolerance
will enable the connection to be reestablished
6. Review the settings, then click Submit. The wizard makes the initial connection to HPE GreenLake and returns the
subscription key.
Install the HPE Storage Array 40
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
Need help?
General
