• Frame size in bytes – User specified value
Ensure that your network switches support the selected frame size.
Note: If Jumbo frames are selected, ensure that they are configured end to end. To confirm that Jumbo
frames are supported, perform an end-to-end ping with the jumbo frame size and without fragmentation;
for example: ping <hostname> -f -l 8972
The data port IP addresses are assigned to interface pairs, such as eth5 on controller A and eth5 on controller B.
If one controller fails, the corresponding port on the remaining controller still has data access. At least one interface
pair must be configured. However, a minimum of two is recommended.
Note: To add a data subnet, click Add Data Subnet, provide the required information.
11. Provide Interface Assignment information for the following sections and click Next:
a) Interface Assignment:
For each IP interface, assign a subnet and a Data IP address within the specified network. For inactive interfaces, assign
the "None" subnet.
b) FC Interface (Fibre Channel arrays only):
This section displays the link status for all Fibre Channel ports. No configuration is required.
c) Diagnostic IP:
• Controller A diagnostic IP address within the specified network
• Controller B diagnostic IP address within the specified network
12. Provide the following Domain information and click Next:
a) Domain Name
b) IP address of your DNS Servers
You can list up to five DNS servers.
13. Provide the following Time information and click Next:
a) Time (NTP) Server
Type the hostname or IP address of your NTP server.
b) Time Zone
Choose the time zone the array is located in.
14. Provide Support information for the following sections and click Finish.
a) Email Alerts
• From Address
This is the email address used by the array when sending email alerts. It does not need to be a real email address,
but it must be in the proper address format. Include the group or array name for easy identification.
• Send to Addresses
HPE recommends that you check the Send event data to HPE Storage Support check box.
• Simple Mail Transfer Protocol (SMTP) server hostname or IP address
b) Diagnostic Analysis
Checking the Send Diagnostic Analysis data to HPE Storage Support check box enabless support to monitor your
array, notify you of problems, and provide solutions.
c) HTTP Proxy
Install the HPE Storage Array 45
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
Need help?
General
