HPE OfficeConnect 1950 Series Getting Started Guide

30
Solution
To resolve the problem:
1. Verify that the switch is securely connected to the RPS.
2. Verify that the RPS is operating correctly.
3. Verify that the operating temperature of the switch is in the acceptable range, and the power
supply has good ventilation. Over-temperature can cause the power supply to stop working and
enter the protection state.
4. If the problem persists, contact Hewlett Packard Enterprise Support.
Concurrent RPS and AC input failure
Symptom
• The system status LED is off.
It indicates that both the AC input and RPS input have failed. To resolve the problem, see
"Solution 1."
• The sy
stem status LED is on but the RPS status LED is steady yellow.
It indicates that the AC input has failed. To resolve the problem, see "Solution 2."
• The sy
stem status LED is on but the RPS status LED is off.
It indicates that the RPS input has failed. To resolve the problem, see "Solution 3."
Solution 1
To resolve the problem:
1. Verify that the AC power cord is securely connected to the switch, and the AC-input power
receptacle on the switch and the connected AC power outlet are in good condition.
2. Verify that the AC power source is operating correctly.
3. Verify that the switch is securely connected to the RPS.
4. Verify that the RPS is operating correctly.
5. Verify that the operating temperature of the switch is in the acceptable range, and the power
supply has good ventilation. Over-temperature can cause the power supply to stop working and
enter the protection state.
6. If the problem persists, contact Hewlett Packard Enterprise Support.
Solution 2
To resolve the problem:
1. Verify that the AC power cord is securely connected to the switch, and the AC-input power
receptacle on the switch and the connected AC power outlet are in good condition.
2. Verify that the AC power source is operating correctly.
3. If the problem persists, contact Hewlett Packard Enterprise Support.
Solution 3
To resolve the problem:
1. Verify that the switch is securely connected to the RPS.
2. Verify that the RPS is operating correctly.
3. If the problem persists, contact Hewlett Packard Enterprise Support.

HPE OfficeConnect 1950 Series Specifications

General

Model	HPE OfficeConnect 1950 Series
Switch Type	Managed
Layer	Layer 2/3
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Routing Protocol	Static, RIP, OSPF
Operating Temperature	0°C to 45°C
QoS Support	Yes
Ports	24 or 48 Gigabit Ethernet ports
10G Ports	Optional 2 or 4 SFP+ ports
PoE Support	Yes
Stacking	Yes (up to 4 switches)
Management	Web-based, SNMP, CLI
Security	802.1X, ACLs, Port Security
Forwarding Rate	Up to 131 Mpps
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Humidity	10% to 90% non-condensing