HPE OfficeConnect 1950 Series Getting Started Guide

5
Installing the switch
CAUTION:
Keep the tamperproof seal on a mounting screw on the chassis cover intact. If you want to open the
chassis, contact Hewlett Packard Enterprise for permission. Otherwise, Hewlett Packard Enterprise
shall not be liable for any consequences.
Figure 1 Hardware installation flow
Start
Install the switch
Ground the swtich
Connect power cords
Verify the installation
Turn on the circuit
breakers
Operating correctly?
Turn off the circuit
breakers
Troubleshoot the
switch
No
End
Yes
Install transceiver modules
and cables

HPE OfficeConnect 1950 Series Specifications

General

Model	HPE OfficeConnect 1950 Series
Switch Type	Managed
Layer	Layer 2/3
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Routing Protocol	Static, RIP, OSPF
Operating Temperature	0°C to 45°C
QoS Support	Yes
Ports	24 or 48 Gigabit Ethernet ports
10G Ports	Optional 2 or 4 SFP+ ports
PoE Support	Yes
Stacking	Yes (up to 4 switches)
Management	Web-based, SNMP, CLI
Security	802.1X, ACLs, Port Security
Forwarding Rate	Up to 131 Mpps
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Humidity	10% to 90% non-condensing