HPE OfficeConnect 1950 Series Getting Started Guide

3
• Electromagnetic wave radiation.
• Common impedance (including the grounding system) coupling.
To prevent EMI, use the following guidelines:
• If AC power is used, use a single-phase three-wire power receptacle with protective earth (PE)
to filter interference from the power grid.
• Keep the switch far away from radio transmitting stations, radar stations, and high-frequency
devices to make sure the EMI levels do not exceed the compliant range.
• Use electromagnetic shielding when necessary. For example, use shielded interface cables.
Laser safety
WARNING!
Do not stare into any fiber port when the switch has power. The laser light emitted from the optical
fiber might hurt your eyes.
The HPE OfficeConnect 1950 switches are Class 1 laser devices.
Installation tools
The following installation tools are user supplied:
• Flat-blade screwdriver
• Phillips screwdriver
• ESD wrist strap
Installation accessories
Table 4 Installation accessories
Product
code
Description Quantity Applicable models
5066-0850
1 U four-hole mounting bracket
kit (including one pair of
mounting brackets and eight
M4 countersunk screws)
(provided)
1 kit
• HPE 1950 48G 2SFP+ 2XGT
• HPE 1950 24G 2SFP+ 2XGT
PoE+(370W)
• HPE 1950 48G 2SFP+ 2XGT
PoE+(370W)
• HPE 1950 12XGT 4SFP+
5184-6978
1 U two-hole mounting bracket
kit (including one pair of
mounting brackets and four M4
countersunk screws) (provided)
1 kit
HPE 1950 24G 2SFP+ 2XGT

HPE OfficeConnect 1950 Series Specifications

General

Model	HPE OfficeConnect 1950 Series
Switch Type	Managed
Layer	Layer 2/3
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Routing Protocol	Static, RIP, OSPF
Operating Temperature	0°C to 45°C
QoS Support	Yes
Ports	24 or 48 Gigabit Ethernet ports
10G Ports	Optional 2 or 4 SFP+ ports
PoE Support	Yes
Stacking	Yes (up to 4 switches)
Management	Web-based, SNMP, CLI
Security	802.1X, ACLs, Port Security
Forwarding Rate	Up to 131 Mpps
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Humidity	10% to 90% non-condensing