HPE OfficeConnect 1950 Series Getting Started Guide

21
Figure 24 Software Installation
7. Click Finish.
Figure 25 Completing the device driver installation wizard
Setting terminal parameters
To access the switch through the console port, you must run a terminal emulator program,
TeraTermPro or PuTTY, on the configuration terminal. For information about using a terminal
emulator program, see the program's user guide.

HPE OfficeConnect 1950 Series Specifications

General

Model	HPE OfficeConnect 1950 Series
Switch Type	Managed
Layer	Layer 2/3
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Routing Protocol	Static, RIP, OSPF
Operating Temperature	0°C to 45°C
QoS Support	Yes
Ports	24 or 48 Gigabit Ethernet ports
10G Ports	Optional 2 or 4 SFP+ ports
PoE Support	Yes
Stacking	Yes (up to 4 switches)
Management	Web-based, SNMP, CLI
Security	802.1X, ACLs, Port Security
Forwarding Rate	Up to 131 Mpps
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Humidity	10% to 90% non-condensing