To Next Page

To Previous Page

The following are the required terminal settings:

• Bits per second—38400.

• Data bits—8.

• Stop bits—1.

• Parity—None.

• Flow control—None.

Powering on the switch

Before powering on the switch, verify that the following requirements are met:

• The power cord is correctly connected.

• The input power voltage meets the requirement of the switch.

• The console cable is correctly connected.

• The configuration terminal (a PC, for example) has started, and its serial port settings are

consistent with the console port settings on the switch.

Power on the switch. During the startup process, you can access Boot ROM menus to perform tasks

such as software upgrade and file management. The Boot ROM interface and menu options differ

with software versions. For more information about Boot ROM menu options, see the release notes

for the specific software version.

After the startup completes, you can access the CLI to configure the switch.

For more information about the configuration commands and CLI, see the user guide for the switch.

Other manuals for HPE OfficeConnect 1950 Series

Questions and Answers:

Need help?

Do you have a question about the HPE OfficeConnect 1950 Series and is the answer not in the manual?

General