HPE OfficeConnect 1950 Series Getting Started Guide

31
Configuration terminal display problems
No display
Symptom
The configuration terminal does not display any information when the switch is powered on.
Solution
To resolve the problem:
1. Verify that the power system is operating correctly.
2. Verify that the switch is operating correctly.
3. Verify that the console cable has been connected correctly.
4. Verify that the following settings are configured for the terminal:
{ Baud rate—38400.
{ Data bits—8.
{ Parity—None.
{ Stop bits—1.
{ Flow control—None.
5. Verify that the console cable is not faulty.
6. If the problem persists, contact Hewlett Packard Enterprise Support.
Garbled display
Symptom
The configuration terminal displays garbled text.
Solution
To resolve the problem:
1. Verify that the following settings are configured for the terminal:
{ Baud rate—38400.
{ Data bits—8.
{ Parity—None.
{ Stop bits—1.
{ Flow control—None.
2. If the problem persists, contact Hewlett Packard Enterprise Support.

HPE OfficeConnect 1950 Series Specifications

General

Model	HPE OfficeConnect 1950 Series
Switch Type	Managed
Layer	Layer 2/3
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Routing Protocol	Static, RIP, OSPF
Operating Temperature	0°C to 45°C
QoS Support	Yes
Ports	24 or 48 Gigabit Ethernet ports
10G Ports	Optional 2 or 4 SFP+ ports
PoE Support	Yes
Stacking	Yes (up to 4 switches)
Management	Web-based, SNMP, CLI
Security	802.1X, ACLs, Port Security
Forwarding Rate	Up to 131 Mpps
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Humidity	10% to 90% non-condensing