Item Description Status
3 NIC status LED* Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network active
O = No network activity
4 UID button/LED* Solid blue = Activated
Flashing blue:
• 1 Hz/cycle per sec = Remote management or firmware
upgrade in progress
• 4 Hz/cycle per sec = iLO manual reboot sequence initiated
• 8 Hz/cycle per sec = iLO manual reboot sequence in
progress
O = Deactivated
*When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see "Power
fault LEDs."
**If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
†Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or
the power button cable is disconnected.
LFF 12-drive model front panel LEDs and button
Component identification
11
To Next Page
Loading...
