HPE ProLiant DL380 Gen10 - Page 12

Item Description Status
1 Health LED* Solid green = Normal
Flashing green (1 Hz/cycle per sec) = iLO is rebooting
Flashing amber = System degraded
Flashing red (1 Hz/cycle per sec) = System critical**
2 Power On/Standby button and
system power LED*
Solid green = System on
Flashing green (1 Hz/cycle per sec) = Performing power on
sequence
Solid amber = System in standby
O = No power present†
3 NIC status LED* Solid green = Link to network
Flashing green (1 Hz/cycle per sec) = Network active
O = No network activity
4 UID button/LED* Solid blue = Activated
Flashing blue:
• 1 Hz/cycle per sec = Remote management or firmware
upgrade in progress
• 4 Hz/cycle per sec = iLO manual reboot sequence initiated
• 8 Hz/cycle per sec = iLO manual reboot sequence in
progress
O = Deactivated
*When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see "Power
fault LEDs."
**If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
†Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or
the power button cable is disconnected.
Component identification
12