HPE ProLiant DL385 Gen10 - Removing and Replacing the Pcie Riser Blank

• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Disconnect any internal cables that are connected to the expansion board.
7. Release the full-length expansion board retainer.
8. Remove the PCIe riser cage.
To replace the component, reverse the removal procedure.
Removing and replacing the PCIe riser blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have
either an expansion slot cover or an expansion board installed.
Procedure
1.
Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
Removal and replacement procedures
47