3. Do one of the following:
• Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
5. If installed, remove the tertiary riser cage.
6. Locate the battery on the system board.
7. Use a small flat-bladed, nonconductive tool to carefully lift the front of the battery from the socket.
8. Remove the battery.
9.
Install the system battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or an authorized
service provider.
Removing and replacing the system board
Removing the system board
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Removal and replacement procedures
91
To Next Page
Loading...
