HPE ProLiant DL385 Gen10 - Removing and Replacing an Energy Pack

16. Install the air bale
17. Install the access panel.
18.
Install the server into the rack.
19.
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Power up the server.
Removing and replacing an energy pack
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4. Remove the access panel.
5. Do one of the following:
•
Removing the air bale.
• Remove the 4LFF midplane cage (Removing and replacing a 4LFF midplane cage).
88
Removal and replacement procedures