HPE ProLiant DL385 Gen10 - Removing and Replacing an Expansion Board

3. Do one of the following:
• Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
5. Remove the PCIe riser cage:
• Primary or secondary PCIe riser cage (Removing and replacing the primary or secondary PCIe riser cages)
• Tertiary PCIe riser cage (Removing and replacing the tertiary PCIe riser cage)
6. Remove the expansion slot blank.
To replace the component, reverse the removal procedure.
Removing and replacing an expansion board
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the server by removing the power cord. The front panel Power On/Standby button does not shut
o system power.
Portions of the power supply and some internal circuitry remain active until AC power is removed.
Procedure
1.
Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect any external cables that are connected to the expansion board.
4. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
5. Remove the access panel.
Removal and replacement procedures
51