HPE ProLiant DL385 Gen10 - Removing and Replacing a Rear Serial Port Interface (Tertiary Riser); Removing a Rear Serial Port Interface (Tertiary)

• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Using a T-10 Torx screwdriver, remove the screws securing the serial port. Then, disconnect and remove the serial
cable.
To replace the component, reverse the removal procedure.
Removing and replacing a rear serial port interface (tertiary riser)
Removing a rear serial port interface (tertiary)
Procedure
1. Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4. Remove the access panel.
5. Disconnect the cable.
6. Remove the tertiary riser cage.
7. Using a T-10 Torx screwdriver, remove the serial port interface.
Removal and replacement procedures
71