HPE ProLiant DL385 Gen10 - Replacing a Rear Serial Port Interface (Tertiary); Removing and Replacing an SFF Power Switch Module

Replacing a rear serial port interface (tertiary)
Procedure
1.
Install the serial port interface.
2.
Connect the cable.
3.
Install the riser.
Removing and replacing an SFF power switch module
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
Power down the server.
2.
Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
3. Remove the access panel.
4. Disconnect cables from the power switch module.
5. Remove the power switch module.
72
Removal and replacement procedures