HPE ProLiant DL385 Gen10 - Removing and Replacing the Small Form Factor Universal Media Bay

To replace the component, reverse the removal procedure.
Removing and replacing the small form factor universal media bay
Procedure
1.
Power down the server.
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
4.
Remove the access panel.
5.
Remove all hot-plug hard drives (Removing and replacing drives).
6. Remove the fan cage (
Removing and replacing the fan cage).
7. Disconnect all cables from the universal media bay.
8. Remove the universal media bay.
54
Removal and replacement procedures