Item Description
1
1 Type-p Smart Array controller connected to the controller backup power
connector
2 Energy pack connected to the energy pack connector
1
Your server might appear different.
8. Install the fan cage.
9. Install the access panel (Installing the access panel on page 56).
10. Install the server into the rack (Installing the server into the rack on page 48).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server on page 53.
Installing an internal microSD card
Procedure
1. Powering down the server on page 53.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
152 Installing hardware options
To Next Page
Loading...
