HPE ProLiant DL560 Gen10 - Installing a Riser Board into the Primary and Secondary Pcie Riser Cages

• Quad Slimline riser board with 4 x8 Slimline NVMe ports.
• 3-slot riser board with 3 x8 connections and 1 x8 Slimline NVMe connection.
• 3-slot riser board with 2 x8, 1 x16, and 2 M.2 SATA connections.
• 3-slot riser board with 2 x8 and 1 x16 connections.
• 2-slot riser board with 2 x16 connections.
Secondary PCIe Riser Board
The secondary PCIe riser cage supports installation of the following riser boards:
• Quad Slimline riser board with 4 x8 Slimline NVMe connections.
• 3-slot riser board with 3 x8 connections and 1 x8 Slimline NVMe port.
• 3-slot riser board with 2 x8 and 1 x16 connections.
• 2-slot riser board with 2 x16 connections.
Tertiary PCIe Riser Board
The tertiary PCIe riser cage supports installation of the following riser boards:
• 2-slot riser with 2 x8 connections.
• 2-slot riser with 1 x8 connection and 1 x8 Slimline NVMe port.
• 2-port riser with 2 x8 Slimline NVMe connections.
Installing a riser board into the primary and secondary PCIe riser cages
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Powering down the server on page 53.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 53).
• Remove the server from the rack (Removing the server from the rack on page 54).
4. Remove the access panel (Removing the access panel on page 55).
Installing hardware options 93