Installing an intrusion detection switch
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure
1. Powering down the server on page 53.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 53).
• Remove the server from the rack (Removing the server from the rack on page 54).
4. Remove the access panel (Removing the access panel on page 55).
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
5. Install the intrusion detection switch.
6. Install the access panel (Installing the access panel on page 56).
7. Install the server into the rack (Installing the server into the rack on page 48).
8. Connect each power cord to the server.
154 Installing hardware options
To Next Page
Loading...
