HPE ProLiant e910

Removing a component from the iLO Repository
Prerequisites
• Configure iLO Settings privilege
• The component is not in an install set.
• The component is not part of a queued task.
Procedure
1. Click Firmware & OS Software in the navigation tree, and then click the iLO Repository tab.
2.
Click .
iLO prompts you to confirm the request.
3. Click Yes, remove.
The component is removed.
Removing all components from the iLO Repository
Prerequisites
• Configure iLO Settings privilege
• The components are not in an install set.
• The components are not part of a queued task.
Procedure
1.
Click Firmware & OS Software in the navigation tree, and then click the iLO Repository tab.
2.
Click Remove all.
iLO prompts you to confirm the request.
3.
Click Yes, remove all.
The components are removed.
Viewing iLO Repository summary and component details
Procedure
1. Click Firmware & OS Software in the navigation tree, and then click the iLO Repository tab.
2. (Optional) To sort by a table column, click the column heading.
To change the sort order to ascending or descending, click the column heading again or click the arrow icon next to the
column heading.
3. (Optional) To view detailed component information, click an individual component.
iLO Repository storage details
The Summary section of the iLO Repository page displays the following details about the iLO Repository storage use:
88 Using HPE iLO 5