HPE ProLiant ML30 Gen10

Specifications
Environmental specifications
Specification Value
Temperature range
1
—
Operating 10°C to 35°C (50°F to 95°F)
Nonoperating -30°C to 60°C (-22°F to 140°F)
Relative humidity (noncondensing)
—
Operating
10% to 90%
28°C (824°F ) maximum web bulb temperature
Nonoperating
5% to 95%
387°C (1017°F ), maximum wet bulb temperature
1
All temperature ratings shown are for sea level. An altitude derating of
10° per 3048 m (18°F per 1000 ft) to 3048 m (10000 ft) is
applicable. No direct sunlight allowed.
For certain approved hardware configurations, the supported system inlet temperature range is extended:
• 5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of 10°C per every
175 m (18°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m (10000 ft).
• 40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 10°C per every 125 m (18°F per every 410
ft) above 900 m (2953 ft) to a maximum of 3048 m (10000 ft).
Server specifications
Specification
Value
Height 3683 cm (1450 in)
Depth 4750 cm (1870 in)
Width 1750 cm (689 in)
Weight (maximum load, approximate values)
—
Four-bay LFF non-hot-plug drive model 1524 kg (3359 lb)
Four-bay LFF hot-plug drive model 1760 kg (3880 lb)
Eight-bay SFF hot-plug drive model 1550 kg (3417 lb)
Power supply specifications
Depending on the installed options and the regional location where the server was purchased, the server can be
configured with one of the following power supplies:
Specifications
133