13. If you intend to install an M.2 SSD on the enablement board, install it now.
14. If you intend to install the serial port cable,
install it now.
15.
If removed, install the air bale.
16.
Install the access panel.
17.
Install the front bezel.
18.
Do one of the following:
• If the server is in tower mode: Position the tower server for operation.
• If the server is in rack mode:
Install the server on the tray.
19.
Connect all peripheral cables to the server.
20.
Connect the power cords:
a.
Connect each power cord to the server.
b.
Connect each power cord to the power source.
21.
Power up the server.
22. If you plan to use the iLO Dedicated Network Port, use the iLO web interface to enable this port.
For more information, see the Enabling the iLO Dedicated Network Port through the iLO web interface section in the
iLO user guide on the
Hewlett Packard Enterprise website.
The installation is complete.
Installing the serial port cable
Prerequisites
Before you perform this procedure, make sure that:
Hardware options installation
73
To Next Page
Loading...
