4. Install the SFF drive.
5.
If the drive is installed in an empty drive cage after the initial system boot, reboot the system to maintain optimal
ventilation.
6.
Determine the status of the drive from the drive LED definitions.
7.
Install the front bezel.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise
website.
Power supply options
Depending on the installed options and the regional location where the server was purchased, the server can be
configured with one of the following power supplies:
•
HPE 350W E-star 1.0 Non-hot-plug Power Supply
•
HPE 500W Flex Slot Platinum Hot-plug Low Halogen Power Supply
Hot-plug power supply calculations
For more information on the hot-plug power supply and calculators to determine server power consumption in various
system configurations, see the Hewlett Packard Enterprise Power Advisor website (http://www.hpe.com/info/
poweradvisor/online).
54
Hardware options installation
To Next Page
Loading...
