HPE ProLiant ML30 Gen10

4. Do one of the following:
• If the server is in tower mode: Position the tower server for hardware configuration.
• If the server is in rack mode:
Remove the server from the rack.
5.
Remove the front bezel.
6. Remove the access panel.
7. Remove the air bale:
a. Lift the front end of the bale from the chassis.
b. Remove the bale from the slots on the rear chassis.
Install the air bale
CAUTION: For proper cooling, do not operate the server without the access panel,
bales, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1. Install the air
bale:
a. Insert the tabs on the bale into the slots on the rear chassis.
b. Press the front end of the bale into the chassis.
Operations
29