13. Slide the optical drive assembly into the media bay until it clicks into place.
14.
Connect the optical drive SATA-power Y-cable.
15.
If removed,
install the air bale.
16.
Install the access panel.
17.
Install the front bezel.
18.
Do one of the following:
• If the server is in tower mode:
Position the tower server for operation.
• If the server is in rack mode: Install the server on the tray.
19. Connect all peripheral cables to the server.
20. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
21.
Power up the server.
The installation is complete.
Hardware options installation
65
To Next Page
Loading...
