HPE ProLiant ML30 Gen10

• If the server is in tower mode: Position the tower server for hardware configuration.
• If the server is in rack mode: Remove the server from the rack.
5. Remove the front bezel.
6. Remove the access panel.
7. If installed, remove the air bale.
8. Remove the alignment screws:
• If installing an M.22242 or 2280 SSD, remove both the hex nut and Phillips screw.
• If installing the M.222110, remove only the Phillips screw. Retain the hex nut.
9. Install the hex nut screw on 2242 or 2280 stando position on the system board.
10. Install the M.2 SSD:
78
Hardware options installation