HPE R/T3000 G2 User Manual

Installation 19
Attaching the UPS front bezel
Connecting the host computer
CAUTION: Only one communications port can be connected to the host computer.
Connecting more than one will result in unexpected UPS behavior. If an option card is installed,
the serial and USB communications ports are automatically disabled.
Connect the UPS to a host computer using either the USB cable or the DB9 serial cable included with the
UPS. Install HPE Power Protector on the host computer. See the Hewlett Packard Enterprise website
(http://www.hpe.com/info/rackandpower) to download the latest version.
NOTE: To install and configure the software, see the software user guide. The software user
guide is available for download from the Hewlett Packard Enterprise website
(http://www.hpe.com/info/rackandpower).

HPE R/T3000 G2 Specifications

General

Power Capacity	3000 VA
Battery Type	Sealed Lead-Acid (SLA)
Output Power Capacity	2700 Watts
Rack Height	2U
Input Frequency	50/60 Hz
Output Frequency	50/60 Hz
Efficiency	Up to 95%
Operating Humidity	0 to 95% non-condensing
Form Factor	Rack/Tower
Interface	USB, Serial
Product Type	UPS
Battery Runtime	Varies by load
Transfer Time	4-6 ms
Operating Temperature	0 to 40°C (32 to 104°F)
Warranty	3 years
Nominal Output Voltage	120 V, 208 V, 230 V
Noise Level	40-50 dB