HPE R/T3000 G2

Maintenance 50
3.
Remove the two screws securing the option card and slide the card out.
To replace the component, reverse the removal procedure.
NOTE: Replacing the option card might require power protector software to be restarted or
reconfigured.
Updating the UPS firmware
To update the UPS firmware, see the Hewlett Packard Enterprise website
(http://www.hpe.com/info/rackandpower).
Configuring a USB to serial converter
NOTE: This procedure was tested on the Windows
®
XP Professional, Windows Server
®
2003, and Windows
®
Vista Enterprise operating systems using the USB to serial converter
(part number 304098-001). Depending on your system configuration, a driver download might
be required to successfully install the converter. The driver can be downloaded from the
USB-Drivers website (http://www.usb-drivers.com/drivers/123/123294.htm).
To configure a USB port to the COM 1 port on systems that do not have available serial ports:
1. Connect the USB to serial converter to the USB port on your system.
2. For Windows Vista, click Start, select Control Panel, double-click System and Maintenance, and
then skip to step 4.
-or-
For Windows XP, click Start, select Control Panel, click Performance and Maintenance, and then
click System.
-or-
For Windows Server, click Start, select Control Panel, and then double-click System.
3. Click the Hardware tab.
4. Click Device Manager. The Device Manager screen appears.
5. In the tree displayed in the left panel, click the Ports (COM & LPT) branch to expand.