SEBU7833-03 71
Maintenance Section
Fuel System Secondary Filter - Replace
g01118416
Illustration 46
(1) Screw
(2) Elemen
t
(3) Glass b
owl
(4) S ensor
connection
(5) Drain
(6) Bottom c
over
1. Place a suitable container below the water
separator
.
2. Open the drain (5). Allow the fluidtodraininto
the contai
ner.
3. When clean fuel drains from the water separator
close the d
rain (5). Tighten the drain by hand
pressure only. Dispose of the drained fluid
correctly.
i02469473
Fuel System Secondary Filter -
Replace
Fuel leaked or spilled onto hot surfaces or elec-
trical components can cause a fire. To help pre-
vent possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Do not allow dir
t to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel sy
stem component.
Element filter
Turn the valves for the fuel lines (if equipped) to the
OFF position b
efore performing this maintenance.
Place a tray under the fuel filter in order to catch
any fuel that might spill. Clean up any spilled fuel
immediately
.
g01010637
Illustration 47
(1) Dra in
(2) F ilter bowl
1. Close the valves for the fuel lines (if equipped).
2. Clean the outside of the fuel filter assembly. Open
the fuel drain (1) and drain the fuel into a suitable
container.
This document is printed from SPI². Not for Resale.
To Next Page
Loading...
