HTC 2500 iX - Operation; Driving the Machine

35
Operation
Driving the machine
The rst item to check after starting up the engine is to
ensure that the MAIN POWER SYSTEM READY lamp (1)
is lit (see gure below). This indicates that the voltage and
frequency from the generator are correct, and that the power
can be turned on. The power is turned on by pressing in the
ELECTRIC POWER ON button (2). When the ELECTRIC
POWER ON button has been pressed in, the MAIN POWER
ON lamp (3) lights up.
The machine’s front wheels are equipped with brakes that
are turned on when the STEERING button is in the OFF po-
sition (see gure below). As long as the button is in this posi-
tion, the machine’s wheels remain locked. In order to drive
the machine, check that the control is in neutral position and
set STEERING to the ON position. The machine is now not
braked, which is important to known when e.g. starting on
an incline. Pay attention to the fact that power load AMP-left
or AMP-right will not exceed the recommended power output
0
I
II
III
OK
Ste
ering
Grinding
OFF
ON
OFF
ON
OFF
Off
ON
On
OFF
ON
OK
VAC
Co
ntrol
Ign
itio
n
G
ri
n
d
in
g
H
e
a
d
DOW
N
UP
Grinding
Speed
Warning
Main Power
Electric
Power
M
ain
po
w
e
r O
n
Main powe
r
System Ready
HTC 2500 iX
OFF
ON
OFF
Off
ON
On
Ignition
Grinding Head
DOWN
UP
Grinding
Speed
Warning
Main Power
Electric
Power
Main power On
Main power
System Ready
HTC 2500 iX
1
2
0
I
II
III
OK
Steering
Grinding
OFF
ON
OFF
ON
OFF
Off
ON
On
OFF
ON
OK
VAC
Control
Ign
itio
n
G
ri
n
d
in
g
H
ea
d
DOW
N
UP
Grinding
Speed
Warning
Main Power
Electric
Power
M
ain
p
o
w
er
O
n
Main power
System Ready
HTC 2500 iX
OK
Steering
Grinding
OFF
ON
OFF
ON
OFF
ON
OK
VAC Control
Ignition
Grinding Head
DOWN
UP
Grinding
Speed
3