Huawei CX600-X2-M Series - Structure

5.8.2 Structure
The 16xE1 cable uses the Anea 96 connector on one end, as shown in Figure 5-7.
Figure 5-7 Appearance of the 16×E1 cable
Figure 5-8 shows the structure of the 16xE1 cable.
Figure 5-8 Structure of the 16×E1 cable
l 75-ohm 16×E1 cable wiring
Table 5-19 describes the wiring of the 75-ohm 16xE1 cable. In the table, Tip indicates the
anode and Ring indicates the cathode, and the pairs are numbered from 1 to 32.
Table 5-19 75-ohm 16×E1 cable wiring
Pin Cable Remar
ks
Pin Cable Remar
ks
Wire Pair
No.
Wire Pair
No.
1 Tip 1 R0 25 Tip 2 T0
2 Ring 26 Ring
HUAWEI CX600-X1-M/CX600-X2-M Series Metro
Services Platform
Hardware Description 5 Cables
Issue 03 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
147