Huawei FusionModule800 Maintenance Guide

FusionModule800 Smart Small Data Center
Maintenance Guide
4 Troubleshooting
Issue 02 (2016-11-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
24
Cat
ego
ry
Sympt
om
Possible Cause
Measure
Out
doo
r
unit
Abnorm
al noise
is
generate
d during
operatio
n.
The compressor, fan, or
pipes are loose.
Check and secure loose parts.
The
compres
sor does
not
work.
The high and low
pressure switches are
triggered.
Check the high and low pressure switches.
The circuit breaker, fuse,
or cable is disconnected.
Check the main circuit breaker, fuses, and
cables.
The compressor motor is
damaged.
Check whether the motor is damaged.
Replace the motor if it is faulty.
The compressor does not
need to start.
Check for the requirement status on the LCD.
The compressor does not
work.
Check whether the compressor driver is
faulty. Replace the compressor if it is faulty.
The
compres
sor
discharg
e
tempera
ture is
too
high.
The refrigerant loop or
component is blocked.
Clean the loop and components.
The outdoor units are not
installed in right
positions. (The
installation distances
should meet
requirements.)
Install outdoor units in the right positions
based on the installation requirements.
Air enters the refrigerant
loop.
Check the discharge temperature and
pressure. Eliminate and retrieve refrigerant.
Refill refrigerant.
Heat dissipation is poor
because the condenser is
dirty or blocked.
Clean the condenser fins using a fin brush.
The outdoor fan fails.
Check whether the outdoor fan works
properly.
The refrigerant is
insufficient.
Fill more refrigerant.
The
compres
sor
discharg
e
The refrigerant is
insufficient.
Fill more refrigerant.
The outdoor fan speed
controller fails.
Replace the fan speed controller.

Huawei FusionModule800 Specifications

General

Brand	Huawei
Model	FusionModule800
Category	Storage
Language	English