Huawei FusionServer G5500 - Page 48

NOTE
When only one compute node is configured, select the slots (G530 V2-1 and GP316-1) on the left.
Step 3 Remove the G530 V2.
NOTE
The half-width compute node configuration supports the removal of a single compute node. If the G530 V2-1
and GP316-1 are removed, the G530 V2-2 and GP316-2 can work properly, and vice versa.
1. Press the unlock button on the G530 V2. See (1) in Figure 3-8.
Figure 3-8 Removing a G530 V2
2. Open the ejector lever on the G530 V2 completely. See (2) in Figure 3-8.
3. Pull the G530 V2 horizontally out of the chassis. See (3) in Figure 3-8.
4. Close the ejector lever on the G530 V2. See (4) in Figure 3-8.
5. Place the removed G530 V2 in an ESD bag.
NOTICE
An ESD bag can hold only one G530 V2.
----End
FusionServer G5500 Server
User Guide
3 Basic Operations
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
40