Huawei FusionServer G5500 - Page 64

Figure 4-6 Incorrect operations
Step 3 Remove the partition board.
NOTE
Perform this operation only when there is a partition board in the chassis where the full-width compute
module is to be installed.
1. Loosen the five screws that secure the partition board to the top of the chassis and the
four screws that secure the partition board to the bottom of the chassis. See (1) and (2) in
Figure 4-7.
2. Press the air baffle in the chassis.
NOTE
The air baffle must be pressed during the entire removal process of the partition board.
3. Push the partition board on the upper left to tilt it rightwards. See (3) and (4) in Figure
4-7.
Figure 4-7 Removing a partition board
NOTICE
Do not hold and pull the die casting part at the front end of the partition board because
this operation may cause the die casting to be unrivaled and disconnected from the sheet
metal plate.
4. Hold the sheet metal plate at the rear end of the partition board to remove the partition
board. See (5) in Figure 4-7.
5. After the partition board is removed, release the air baffle. The air baffle automatically
pops up.
FusionServer G5500 Server
User Guide
4 Setup
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
56