Data
l IP address of the management module management network port
l User name and password for logging in to the management module
For details about the default data for the management module, see Default Data.
Software
PuTTY.exe (third-party software)
Procedure
Connect the client to the management network port.
1 Connect the client to the management network port on the management module using a
network cable, as shown in Figure 5-4.
Figure 5-4 Connecting the client to the management network port
Set the client address.
2 Set the IP address, subnet mask, or route of the client to enable the client to interconnect
with the management network port.
On the client, choose Start > Run, enter cmd, and click OK. Then, run the Ping IP
address of the aggregated management network port command to check whether the
management network port is reachable.
Log in to the management module CLI.
3 On the client, double-click PuTTY.exe.
The PuTTY Configuration window is displayed, as shown in Figure 5-5.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
74
To Next Page
Loading...
