Huawei LUNA2000-2.0MWH Series

To Next Page

To Previous Page

Procedure

Step 1 Choose Maintenance > Connect Device on the SmartLogger WebUI.

Step 2 Click in the upper right corner to start devices in batches.

Figure 8-15 System startup

----End

8.4 Check Alarms

Step 1 Log in to the SmartLogger WebUI and check whether an alarm is generated. If no

alarm is generated, proceed with the power-on operations. If an alarm is

generated, clear the alarm by referring to the handling suggestions.

Step 2 Short-circuit the water sensor and check whether a water alarm is generated on

the SmartLogger WebUI:

● If a water alarm is generated, the water sensor is properly connected. In this

case, the water alarm will be cleared after the short circuit is removed.

● If no water alarm is generated, check whether the water sensor cable is

properly connected.

Figure 8-16 Position of Electrode Water Sensor in Battery Cabin

LUNA2000-2.0MWH Series Smart String ESS

User Manual 8 SmartLogger Web-based Deployment

Huawei LUNA2000-2.0MWH Series - Check Alarms