Figure C-1 Requirements for OT/DT terminals
Crimping an OT or DT Terminal
● Avoid damaging the core wire when stripping a cable.
● The cavity formed after the conductor crimp strip of the OT or DT terminal has
been crimped must wrap around the core wires completely. The core wires
must be in close contact with the OT or DT terminal closely.
● Wrap the wire crimping area with heat-shrink tubing or insulation tape. The
heat-shrink tubing is used in this section as an example.
● Use a heat gun carefully to avoid heat damage to the equipment.
LUNA2000-2.0MWH Series Smart String ESS
User Manual C Crimping an OT or DT Terminal
Issue 08 (2022-11-15) Copyright © Huawei Technologies Co., Ltd. 244
To Next Page
Loading...
