Paint Damage Tools and
Materials
Procedure Description
Deep scratch
(primer damaged,
steel base
material exposed)
Spray paint or
paint, zinc-rich
primer, ne
sandpaper,
anhydrous
alcohol, cotton
cloth, and brush
(required for
repainting a small
area) or paint gun
(required for
repainting a large
area)
large-area
smudges and
rust, use a
paint gun to
spray paint the
area.
4. The paint
coating should
be thin and
even. The
surface should
be smooth.
There must not
be any paint
drops on the
coating.
5. Leave the
repainted area
for about 30
minutes before
performing any
further
operation.
Steps 1, 2, 3, 4,
and 5
Logo and pattern
damage
If a logo or pattern has been
damaged, obtain the logo size and
color number and contact a local
advertisement coating supplier to
formulate a repair solution based on
the logo size, color, and damage.
Dent
1. If a dent is less than 100 mm
2
in
area and 3 mm in depth, ll the
dent with Poly-Putty base and then
perform the same operations as
those for xing deep scratches.
2. If a dent is greater than 100 mm
2
in
area or greater than 3 mm in
depth, contact the local supplier for
an appropriate repainting solution.
Procedure
Step 1 Gently polish the damaged areas using
ne sandpaper to remove smudges or rust.
Figure D-1 Polishing a damaged area using sandpaper
LUNA2000-2.0MWH Series Smart String ESS
User Manual D Repainting the Equipment
Issue 08 (2022-11-15) Copyright © Huawei Technologies Co., Ltd. 247
To Next Page
Loading...
