Huawei OceanStor V5 Series - Replacing an Expansion Module; Replacing an Expansion Module (Disk Enclosure)

Figure 6-108 Indicators on a disk module
1 Running indicator
of the disk
module
2 Alarm/Location
indicator of the
disk module
Step 8
Conrm the replacement.
1. Perform a post-replacement inspection.
After the parts replacement, return to the SmartKit page and click Replaced.
Then complete the parts check after the replacement as prompted.
2. Check system status.
Choose Home > Storage > Routine Maintenance > Health Check to check
the system status again. If any inspection item fails, rectify the fault based on
the suggestions in the inspection report.
3. After the preceding procedure is complete, check services on the host for
storage-related errors.
----End
Follow-up Procedure
After the disk module is replaced, label it to facilitate subsequent operations.
6.6 Replacing an Expansion Module
This section describes how to replace an expansion module.
6.6.1 Replacing an Expansion Module (Disk Enclosure)
This section describes how to replace an expansion module.
Impact on the System
During the replacement of an expansion module, the system switches services
from ports on this module to ports on the other expansion module in the same
OceanStor V5 Series
Parts Replacement 6 Replacing CRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 113