Huawei OceanStor V5 Series - Page 148

Figure 7-4 Add Device Step 2-2: Congure Information
4. Enter congurations, including the user name, password, and port of the
device. In the Login Information area, enter the Username, Password, and
Port of the device to be added. The default value of Port is 22.
– The default user name and password of the storage system are admin and
Admin@storage respectively.
– Run show system server_port server_name=SSH to check whether the SSH port
ID is 22. If the port ID is not 22, run change system server_port
server_name=SSH port_num=22 to change it to 22.
5. Click Finish.
The newly added device is displayed in the device list.
● When a device is added for the rst time or a device certicate is not trusted, a message
is displayed indicating that the connection is not trusted.
● When an SSH server is added for the
rst time or the ngerprint of an SSH server
changes, a message is displayed asking whether you want to continue to register the
SSH server.
Step 6 Click OK, go back to the Health Check page, and click Inspection, as shown in
Figure 7-5.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 139