Figure 7-54 Installing an interface module
Step 10 Connect the cables as labeled.
Step 11 Wait about ve minutes and check the status of the Power indicator on the
controller to determine whether the controller has been powered on, as shown in
Figure 7-55.
● If the Power indicator is steady green, the controller has been powered on.
● If the Power indicator is blinking green and the Alarm indicator is blinking
red, the controller is being located.
● If the Power indicator is blinking green (0.5 Hz), the controller is powered on
and in the BIOS boot process.
● If the Power indicator is blinking green (2 Hz), the controller is in the
operating system boot process or
power-o process.
● If the Power indicator is
o, the controller is absent or powered o.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 192
To Next Page
Loading...
