Huawei OceanStor V5 Series

To Next Page

To Previous Page

Tools and Materials

● ESD wrist strap

● ESD bag

● Labels

Procedure

Step 1 Check status before replacement.

1. Check system status.

Start SmartKit and choose Home > Storage > Routine Maintenance >

Health Check. On the Health Check page, perform inspection as instructed.

For details, see 7.1.2 Checking System Status.

If any items fail the inspection, rectify the faults by performing the recommended

actions in the inspection reports. Ensure that all other parts except the parts to be

replaced are working properly.

2. Check the status of the parts to be replaced.

Start SmartKit and choose Home > Storage > Parts Replacement > Parts

Replacement. On the Parts Replacement page, click FRU Replacement.

Then complete the check before the replacement as prompted. For details, see

7.1.3 Replacing an FRU.

NO TICE

You can proceed to next steps only when all items pass the pre-replacement check

and the replacement page is displayed. If any item fails, rectify the fault as

prompted.

Step 2 Wear an ESD wrist strap.

Step 3 Press the latch on the assistant cooling unit to release the handles and pull out

the assistant cooling unit, as shown in Figure 7-66.

OceanStor V5 Series

Parts Replacement 7 Replacing FRUs

Huawei OceanStor V5 Series - Page 219