Huawei UPS2000-G Series User Manual

Table 4-15 SNMP card settings
Item Description Default
Value
Value Range
IP alloc. Species the DHCP address
allocating mode. After the
allocating mode is set to
Automatic, an Allocating
dialog box is displayed on the
screen. If allocation succeeds,
the new IP address is
displayed. If allocation fails,
the IP address restores to the
default one: 192.168.0.10. If
the allocating mode is set to
Automatic, you can only
query the IP address but
cannot set the IP address
manually.
NOTE
If the optional card does not
support the DHCP function, the
allocating mode cannot be set to
Automatic on the UPS
monitoring module. You are
advised to upgrade the SNMP
card.
Manual
Manual,
Automatic
IP
address
Set an IP address for the
SNMP card.
192.168.0.10 1.0.0.0–
223.255.255.2
55
Subn.
mask
Set a subnet mask for the
SNMP card.
255.255.255.
0
-
Gateway Set a gateway address for the
SNMP card
192.168.0.1 1.0.0.0–
223.255.255.2
55
2. If a Modbus card is connected, the following parameters are displayed:
Figure 4-26 Modbus card settings
UPS2000-G-(6 kVA-20 kVA)
User Manual 4 Control Panel
Issue 21 (2022-10-13) Copyright © Huawei Technologies Co., Ltd. 67

Huawei UPS2000-G Series Specifications

General

Frequency	50/60 Hz
Output Power Factor	0.9
Humidity	0% to 95% (non-condensing)
Dimensions	Varies by model
Weight	Varies by model
Capacity	1 kVA, 2 kVA, 3 kVA
Input Voltage	220 Vac (120 Vac/208 Vac/230 Vac/240 Vac)
Output Voltage	220/230/240 VAC
Efficiency	Up to 95%
Topology	Double conversion online
Battery Type	Sealed Lead Acid
Communication Ports	USB, RS232
Optional Communication	SNMP
Operating Temperature	0°C to 40°C