Hubbell GAI-TRONICS E3 Console Manual

Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 3 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Define the System’s Parameters
Action
Screen
Identify the system type (Standalone, A-B, N+1).
Set system-wide volume and attenuation levels.
Assign the controller’s network settings such as IP
address (static) or enable DHCP.
Enable/disable event recorder.
Set the maximum mute duration.
Set the maximum attenuation duration.
Set the maximum fault acknowledge duration.
Enable/disable features: mix 2, mix substitution, event
mismatch correction, insert 1 & insert 2.
System Properties (Global Settings on
page 13)
Define the System’s Hardware Devices
Action
Screen
Add Amplifiers
System Properties → Amplifiers
Select the amplifier type.
Edit the amplifier description.
Set the channel ID (1–64).
Set channel zone display.
Enable/disable load testing.
Identify if channel is a standby amp.
Amplifiers (on page 21)
Add Speaker Masters
System Properties → Speaker Masters
Add Audio Channels
Speaker Masters (on page 25)
Add Speaker Remotes
System Properties → Speaker Remotes
Create Speaker Remotes
Speaker Remotes (on page 27)
Add I/O (Input/ Output) Modules
System Properties → I/O Controllers
Add I/O modules.
Select I/O module type.
I/O Controllers screen (on page 46)
Add Modbus Modules
System Properties → Modbus
Configure the E3 Modbus module
Add and configure external IP Modbus modules
Modbus(on page 54)
Define the System’s Live Audio Sources
Action
Screen
Enable Live Audio Sources:
• Page/Party
• telephone interface
• Aux #1–Aux #5
• IP Aux #1–IP Aux #8
Audio Inputs screen (on page 60)
Set the priority of the audio input sources.
Sources Enabled (on page 60)

Hubbell GAI-TRONICS E3 Specifications

General

Brand	Hubbell
Model	GAI-TRONICS E3
Category	Controller
Language	English