Hubsan MINI - Intelligent Battery Functions; Battery Protection Features; Power and Communication Features; Battery Button Operation

10
1.2.3 Intelligent battey functions
1.2.3 Intelligent battey functions
1) Powe display: The battery has a power indicator, which can display the battery
power.
2) Battey stoage potection: After the battery is fully charged and stored for 10
days without any use, it will automatically turn into self-discharge mode to protect it-
self (there may be slight heating during discharging).
3) Balance Potection: The battery automatically balances the cell voltage to protect
against deterioration.
4) Chaging tempeatue potection: When the battery temperature is below 5°C
or above 40°C, it may be damaged. So the battery will not charge at these tempera-
ture values,
5) Ovechage potection: High current charging will seriously damage the battery.
Therefore when the charging current is too high, the battery will automatically stop
charging.
6) Ovechage potection: Overcharging will seriously damage the battery. When
the battery is fully charged, it will automatically stop charging.
7) Ove-dischage potection: Over-discharge will seriously damage the battery.
When the battery is not in use it will stop supplying power at a certain voltage. While
the over-discharge protection will not allow the Drone to start.
8) Shot cicuit potection: When the battery detects a short circuit, it will cut off
to protect itself.
9) Cell damage detection: When the battery is detected to be damaged or severely
unbalanced, the damage will be indicated.
10) Hibenation Potection: When the Drone is powered on but in standby, it will
enter a non-operational state after 20 minutes to maintain charging. When the battery
charge is less than 5%, if the Drone is stationary but not turned off, it will automati-
cally turn off. If the Drone is turned off, the battery will automatically enter the sleep
state to avoid excessive discharge. At this time, short press the off switch, the battery
can be reactivated by charging it.
11) Communication: the aircraft can send information, such as battery voltage and
power, in real time through the communication interface located on the battery, fur-
thermore the information also appears on the display of the radio control.
Short press to check battery level, it will automatically turn
off after 3 seconds.
First short press and then long press to switch on/off, the in-
dicator light turns on or off.
BATTErY BUTTON