Hubsan MINI - Engine Start and Stop Operations

20
3.4.3
3.4.3
Stating and stopping engines
Stating and stopping engines
The conditions for starting the engines must be the following:
1 - The Drone, the Radio Control, the Smartphone or the Tablet must be connected;
2 - The Drone is calibrated with the compass (the App does not require calibration);
3 - The Drone must be positioned horizontally;
4 - The Drone has not locked onto sufficient GPS satellites useful for the flight. Do not
force takeoff;
5 - The power of the drone should be =15%;
STArTING THE ENGINES
Push both sticks into the bottom outer corners. With the engines running, release the sticks.
STOPPING THE ENGINES
Push both sticks into the bottom outer corners. With the engines stopped, release the sticks.
FOrCED STOP OF THE ENGINES
With the Drone in flight it is possible to force the engines to stop by pushing both sticks
in the lower external corners for at least 2 seconds. This function must be used with
extreme caution, since stopping the motors will inevitably cause the Drone to fall, caus-
ing parts to break, furthermore the fall could compromise the safety of people or things.
CONNECTED
Do not move the sticks diagonally down and outwards during flight,
otherwise the motors will shut down causing the Drone to fall.
When in flight, use the sticks gently.
After activating or deactivating the engines, release the sticks.