31
Make sure there are no impurities on the Gimbal before taking off. Avoid shocks to
the Gimbal after turning on the Drone. The Gimbal is built with precision compo-
nents, if damaged they could be damaged compromising its performance.
Take care of your gimbal and camera.
Keep the Gimbal clean, prevent it from coming into contact with sand, stones or
dust otherwise movements could be blocked, affecting its performance.
Do not take off or land on surfaces that could impact the Gimbal as such impacts
could cause malfunctions in the Gimbal's motors.
Do not attach any objects to the camera head, additional weight could affect the
camera's performance and even burn the motor.
Remove the Gimbal protection clip before turning on the Drone.
Reinsert the gimbal latch to protect it during storage or transportation.
Flying in thick fog or clouds can cause "condensation" inside the Gimbal, resulting
in temporary blocking. If this happens, wait for the Gimbal to dry before returning
to regular use.
You can adjust the
angle of the Gimbal by
rotating the control
wheel on the remote
control.
6.3
6.3
Stoing Images and Videos
Stoing Images and Videos
Via an external TF U3 memory card, which depending on the model purchased, can have
a capacity of 16 GB, 32 GB, 64 GB or 128 GB. The system supports hot plugging, therefore
it is possible to insert the TF Card even with the device turned on, however it is preferable
to insert or disconnect the TF Card with the drone turned off.
To Next Page
Loading...
