Hubsan MINI - Aircraft Battery; Battery Charging; Battery Installation

9
The capacity of the lithium battery of the drone is 3000 mAh, for a voltage of 7.2 V,
the standard version is supplied without a charger therefore it is sufficient, to charge
the battery with a phone charger with Micro USB adapter, the time of charging, a 2A
charger, and about 2.5 hours. By purchasing the versions with bag or "combo", a stan-
dard charger is supplied, the charg-
ing time is approximately 90
minutes. Press the button on the
battery once, a series of LEDs will
light up based on the battery
charge.
1 - Connect the power supply to the
AC mains (100V-240V, 50-60 Hz).
2 - Connect the switched off smart
battery to the charging adapter.
3 - The battery level indicator will
flash and indicate the charge level
4 - The smart battery is fully
charged when the power lights are
all off.
Disconnect the battey fom the
powe supply afte chaging.
Smart
Batteries
Smart
charger
mains
adapter
Intelligent
charge manager
1.2.2
1.2.2
Battey installation
Battey installation
2
3
1
Have a 100% chaged battey
Inset the battey into the com-
patment, pess the clips on both
sides of the battey until you hea
the click.
If the battey has been inseted
coectly it should be flush with
the stuctue of the done.
Fo long-tem stoage of the battey, afte using it, echage it
(at least 50%) to avoid compomising its life.
1.2
1.2
A
A
IrCrAFT
IrCrAFT
BATTErY
BATTErY
1.2.1
1.2.1
Battey chaging
Battey chaging